Thank you so much for your involvement with the Owner's Club Forum! We hope you've gotten some great information and had the chance to interact with other owners on the current system.
2015 ss231 honda ob, power to helm/console problem wiring questions
Rudolph
Member Posts: 2 ✭
thanks in advance. no power to console. when console master power
switch turned on, B+power at relay(s) input goes from battery B+ to
zero. checked, still has battery voltage in and out
at stern circuit breaker (also replaced breaker)
relays make no noise/click when console switches turned on.
-trying to diagnose...
-why two 10# red wires exiting deck to ctr console when only one exits stern battery area? Is there a splice somewhere? where?
-why
one 10# black wire exiting deck to ctr console when 3 14# wires exit
stern battery area? are there harness splices somewhere?
-what is the location of harness routing from stern to console, port or starboard- if disassembly needed to try to isolate problem?
-are there any electronic devices and/or splices in harness between stern and console that could cause this?
also, ground at console 1.3 ohms resistance between console and battery
thanks
Answers
-
I'm having the same issue, did you ever figure this out? I'm tempted to just pay for a total rewire.
-
mine was center console boat. there is access panel at base of back side of storage compartment inside console inside corrugated plastic harness sleeve there is a factory splice (one red wire to two red wires) that was corroded, also 4 pin deutsch connector was corroded. bought boat used- not sure when/how they got wet. repaired both and tied up harness so it wasn't just laying on floor. also while disassembled looking for routing i ran new + and - wire from battery area to console along port side of hull, just in case, because original conductors were corroded and wasn't sure crimp connections would stay good.
