Thank you so much for your involvement with the Owner's Club Forum! We hope you've gotten some great information and had the chance to interact with other owners on the current system.
2007 Fundeck 196RE
chtgsandyliving
Member Posts: 4 ✭
Hello,
I replaced the ignition switch on my fundeck and am having an issue now with the kill switch. When the kill switch is pulled, the 10A fuse on the top of the motor blows. THis has happened both times the kill was pulled (one as a test, second as an accident while pulling in to the slip).
When I replaced the ignition, I mirrored the wiring of the old ignition and all works well with the exception of the kill switch.
I believe I have two of the wires crossed. Does anyone have the diagram of color to pin so I can confirm how the ignition should be hooked up?
Thanks!
I replaced the ignition switch on my fundeck and am having an issue now with the kill switch. When the kill switch is pulled, the 10A fuse on the top of the motor blows. THis has happened both times the kill was pulled (one as a test, second as an accident while pulling in to the slip).
When I replaced the ignition, I mirrored the wiring of the old ignition and all works well with the exception of the kill switch.
I believe I have two of the wires crossed. Does anyone have the diagram of color to pin so I can confirm how the ignition should be hooked up?
Thanks!
Comments
-
Edit here - We have checked the wiring on the back of the ignition and all is properly in place. The yellow/red that is responsible for the safety kill, takes a turn before going into the back of the ingition and I cannot figure out why it is isolated to go into the body of the binnacle. Is there a chance the safety in the binnacle is shorted or has an issue that is causing the 10A fuse on the motor to get too much amperage?