Thank you so much for your involvement with the Owner's Club Forum! We hope you've gotten some great information and had the chance to interact with other owners on the current system.
1998 Fundeck hull&floor question
Options
Phoenix0917
Member Posts: 1 ✭
I just acquired a 1998 Fundeck that has the deck removed. The hull has been repainted by the previous owner and looks good and solid. My question is when I go to rebuild my way back up is there plywood on top of the stringers as I can see some in the rear around the motor and gas tank. Also can someone point me into the correct placement of the deck? Not sure if it goes over the lip of the upper boat hull or the edge. I have a rough sketch below. Thanks in advance. If anyone knows of a place i can get a cross section of the boat and any diagrams of the holes in the hull sides are for would be great. I have not gotten into the boat project yet just planning.
Comments
-
The deck in my 2000 226R is foam cored. Wood is OK if you coat both sides and ends with resin. Epoxy if paintingand polyurethane if gelcote.
. -
I recommend you use this pale yellow liquid epoxy solution of West System to ensure a hard and lasting cure. No other products offer superior bonding and protection like this.
