Thank you so much for your involvement with the Owner's Club Forum! We hope you've gotten some great information and had the chance to interact with other owners on the current system.
New guy project, Part II
Team36Grit
Member Posts: 68 ✭✭
Well see....
Hull flipped
Sat on wagon to move for painting (once the time comes
Sat on wagon to move for painting (once the time comes
Comments
-
Painted
Trailer painted
-
New brake assemblies
Bunks and carpet
Bedliner on steps and fenders
-
Back on trailer
New deck drains
Curb built over ski locker, 3 trolling batteries will set here, under console
Deck going back onto hull
-
Gray trim and red stripe painted
-
Outer edge of deck painted
-
Made the cover for fuel line opening, was "open" before.
Brazed brass rod to drain plug, no wrench to find.
And carry a spare in the bilge
LED Trailer lighting finished
-
Mocked-up windshield made from scrap smoked Lexan. Had to wetsand and buff to remove scratches. It got aluminum angle added to corners (in place of blue masking tape).
Working on console seat
PVC rod holders on fence at front corners.
Carpeted motor cover, added doors for storage and access to rear hatches (for batteries)
More smoked Lexan to prevent "reach-throughs"
-
Deck coated with MonstaLiner bed liner (good stuff!)
Console curb was sealed to floor, then lined to prevent any water intrusion.
-
Console set
New fishing seats
-
Spider rigging rod holders installed
Rear nav light stowed under motor well cover
Bow nav light stowed inside door
10 gal bait tank made from drink cooler
